3 thoughts on “How can I use the ordering commands in rhinos? Urgent !!!! Looking at the tall guidance ~”
Marguerite
1. Select the "Upper View Datomant" and click the "Sketch Draw" icon button. You can also choose the outline directly. 2. Draw a closed loop outline and click the upper right corner to exit. The outline in the "Putting Sample convex/matrix" and the "Sample cutting" command must be closed. The contour in the "Putting Sample Nature" command can be closed and the loop can be opened, and the contour in the "Sample Bend" command must be opened. 3. Select "View Standards" and click the "Standard Face" icon button. 4. Set the transition distance with the "upper view benchmark". Or set parameters such as angle. 5, select the new benchmark surface, click the "Sketch Draw" icon button. 6. Draw another closed loop outline and click the upper right corner to exit. 7. Click the "Putting Sample conveyr/matrix" icon button. 8, two drawn outlines are selected under "Outline". You can choose a few more outlines. You can select the existing physical edge or surface. If the shape is not ideal, the green connector in the figure below can change the shape. 9, "thin wall features" can also be made.
The simplicity of you can understand it with a bamboo strip, and then automatically wrap your skeleton with the curved surface after putting it on the same sample.
Simple examples, 2 circles of coaxial axis, one high and one low, after selection, the sample is put out, and the vertebrae came out.
This out of your fingers, you bring a few rings to understand. That is to say, you draw a few circles, according to the distribution, the surface of the fingers is generated after the sample.
Put the sample commands according to the steps of the command box above the rhino software. The point-to-point command-Select the sample curve-press Enter 2 times; note that the sample curve is not a closed wire frame or face domain on the same plane. After the line frame is placed, the outline is generated, and the entity is generated after the face is placed.
1. Select the "Upper View Datomant" and click the "Sketch Draw" icon button. You can also choose the outline directly.
2. Draw a closed loop outline and click the upper right corner to exit. The outline in the "Putting Sample convex/matrix" and the "Sample cutting" command must be closed. The contour in the "Putting Sample Nature" command can be closed and the loop can be opened, and the contour in the "Sample Bend" command must be opened.
3. Select "View Standards" and click the "Standard Face" icon button.
4. Set the transition distance with the "upper view benchmark". Or set parameters such as angle.
5, select the new benchmark surface, click the "Sketch Draw" icon button.
6. Draw another closed loop outline and click the upper right corner to exit.
7. Click the "Putting Sample conveyr/matrix" icon button.
8, two drawn outlines are selected under "Outline". You can choose a few more outlines. You can select the existing physical edge or surface. If the shape is not ideal, the green connector in the figure below can change the shape.
9, "thin wall features" can also be made.
There are detailed animations in the help.
The simplicity of you can understand it with a bamboo strip, and then automatically wrap your skeleton with the curved surface after putting it on the same sample.
Simple examples, 2 circles of coaxial axis, one high and one low, after selection, the sample is put out, and the vertebrae came out.
This out of your fingers, you bring a few rings to understand. That is to say, you draw a few circles, according to the distribution, the surface of the fingers is generated after the sample.
Put the sample commands according to the steps of the command box above the rhino software.
The point-to-point command-Select the sample curve-press Enter 2 times; note that the sample curve is not a closed wire frame or face domain on the same plane. After the line frame is placed, the outline is generated, and the entity is generated after the face is placed.